Ironwood Logo
Select Image 1
Select Image 2


Enter a restroom accented with inlay and experience the allure of contrasting material.

  • Available for partitions made with wood veneer, solid surface, phenolic, and plastic laminate.
  • Renderings in DXF or DWG file format are preferred; other formats may incur file conversion charges.
  • Inlays can be any standard geometric shape.
  • Minimum inlay dimensions are 6” wide and 6" tall.
  • Best results are realized using same-thickness materials.
  • Investigate inlay options in our Configurator.
Things to

Things to Consider

Consider the following in association with inlaid washroom partitions:

  • Inlays may require additional cleaning care.
  • Many cleaning solutions are not appropriate for real wood, if used.
  • Design complexity will likely impact lead time.
  • Best results are realized using same-thickness materials.
  • Inlay doors are not guaranteed in wet areas.
  • As complexity of inlay increases, consideration should be given to using custom prints.
  • Typical minimum radius is 1/4” but may vary by material.

If you have questions about any of these considerations, or have other concerns, please contact us.

Tech Data

Select from the following to download tech data sheets.

pdf symbolInlay Tech Data
pdf symbolWood Species Chart

Available Options


Inlays should be a standard geometric shape or shapes.


Inlay accents can be made from:

  • 3form acrylics
  • Wood Veneer
  • Plastic Laminate (HPL)

If you have further questions about options for inlays, please contact us or see our Inlay Tech Data sheet.


Design Details

Inlays are manufactured by cutting the materials to within 0.001” tolerance of the specified design. This results in no visual gap, but the seal between the pieces cannot be guaranteed to be water-tight. As a result, inlaid partitions should not be used in high-humidity environments or where partitions are cleaned by applying water or other liquids directly.

Inlays can be in any standard geometric shape. They must be at least 6” wide and 6” tall. Inlay patterns should be supplied in DXF or DWG file format. Other formats, such as high-resolution AI, CDR, GIF, or JPEG, are also accepted with an additional charge to cover the conversion cost to DXF or DWG. The amount of this charge depends on the source file format and the level of detail in the inlay(s). Please contact us to determine conversion rates if you cannot provide DXF or DWG versions of your design.


Inlay can be added to the front or back of doors and panels manufactured from solid surface, wood veneer, phenolic, or plastic laminate.

Inlaid accents do not affect style options (such as headrail braced) or size options.


If you have further questions about inlay, please contact us or see our Inlay Tech Data sheet.

Image Needed